Water Detector (WD-1)
Water Detector (WD-1)
The WD-1 water detector can be used in two ways. Firstly, it can be used to easily monitor the floor or a space for water, for example, for leak detection. The other way the WC-1 can be used is as a water verification monitor. When used in this way, the water detector is placed in areas where water will accumulate (or where water is added to the growing medium). Each output (solenoid or pump) on the Aqua-x can be "assigned" to a specific WD-1. Each time the solenoid or pump assigned to the WD-1 is activated by the Aqua-X, the WD-1 must detect water within an adjustable delay time. If no water is detected (pump or solenoid failure), the Aqua-X sends a user alert with the message "irrigation error." Up to 25 WD-1 can be connected to a single Aqua-X.
Use two water detectors (WD-1/2) to activate the new Auto-Fill feature on the Aqua-X Pro. One water detector is placed at the bottom of the nutrient tank, and the other at the top of the tank. When the liquid level drops below the lower sensor, the Aqua-X Pro will activate a solenoid or pump, and the tank will be refilled to the level of the sensor at the top.
*The WD sensors can only detect water leaks from municipal water, well water, or nutrient-rich water. Reverse osmosis (RO) water may contain so few dissolved solids that the Water Detector cannot detect RO water leaks.
Package content:
- 1 x Water Detector 1 x Touch Spot 1 x RJ12 T-Splitter 1 x 16ft RJ12 cable
+31(0)6 23361355